Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur télécharger pdf (Page 14)

User Manual: RENESAS Flash Programmer

14 www.ngxtechnologies.com

Figure 3-10. [Autoprocedure (E.P)] Command Execution Results

(7) System shutdown

Step 1: Disconnect the target cable from the target system.

Remark When supplying VDD power to the target system, turn off the power before removing the

target cable.

Step 2: Unless there are other target microcontrollers to be programmed, click the [File] menu and select

the [Exit] command to close RFP. Because all settings made so far will be saved to a project file, they

can be reused after RFP is restarted.

Step 3: Remove the USB cable from the tool used.

Step 4: Connect the external power supply to the target board then the USER LED(D1) should blink.

Caution:

If an error occurs during the above procedure, see section 5 TROUBLESHOOTING.

Also see the user’s manual of the tool used and execute diagnostic tests.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Pas de commentaire

Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur Page 14