2.1 CAN
The CAN controller of the microcomputer is connected to the CAN transceiver (TJA1040). It
supports CAN physical layer. Also, CAN bus signal is connected to DSUB 9pin female
connector.
CAN 3 CAN 2 CAN 1 CAN 0
CAN 4
JP8
One terminal can be selected by using jumpers from maximum of three multipurpose terminals, and
can be connected to CAN transceiver.
Only one line must be shorted in each jumper.
CAN 4 is in CPU board. JP8 is a power supply jumper of the CAN transceiver. Be short-circuited
usually.
- 6 -
Commentaires sur ces manuels