Renesas FLASH Development Toolkit 3.07 Manuel d'utilisateur télécharger pdf (Page 41)

3.4.8

Reset Pin Settings

[Only if the FDM or E8Direct is selected] Select the ‘Operating Mode’ and ‘Clock Mode’ and if ‘User

Defined’, set the Reset pin settings. Set the ‘Reset Outputs’ and the ‘Reset Setting’ for the mode required

immediately after disconnection. Click the ‘Finish’ button. “*Mode Outputs” sets which pins are driven by

the FDM, “*Mode Setting” sets whether output pins are driven High (checked) or Low (Unchecked).

Notes: Setting the mode pins using the FDM or E8Direct requires caution. Please confirm the pin settings

with the hardware manual even if a default setting is available. Note that in some devices, changing

the mode pin setting changes the maximum supply voltage.

Figure 3-10 FDMRESET Pin Settings

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 145 146

Pas de commentaire

Renesas FLASH Development Toolkit 3.07 Manuel d'utilisateur Page 41