Renesas MCU Board for 4513/4514 Group MCUs M34514T-MCU Manuel d'utilisateur télécharger pdf (Page 23)

( 23 / 42 )

Figure 4.10 Connecting to IC socket for 32-pin SDIP

(2) For 4513 Group

When connecting the M34514T-MCU board to the target system (for 4513 Group):

a. Connecting to the IC socket for 32-pin SDIP on the Target System

Connect the M34514T-MCU board with the IC socket for 32-pin SDIP on the target system

using the 50-wire normal-pitch cable (included) with the M34513T-PTCA pitch converter

board attached. Figure 4.10 depicts the connection between the M34513T-PTCA pitch con-

verter board and the target system. Following products are required for connection to the target

system.

• 100-wire half-pitch cable (40 cm)

• PCA4029 pitch converter board

• 50-wire normal-pitch cable (10 cm)

•M34513T-PTCA pitch converter board

Table 4.9 shows the connector signal assignments of the M34513T-PTCA pitch converter

board. The pin assignments of M34513T-PTCA is the same as for the 32SDIP in 4513 Group.

When connecting the M34513T-PTCA pitch converter board, make sure the No. 1 pin position

of each connector is aligned with that of cable. To avoid damage to the emulator and target

system, be careful of the connection.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Pas de commentaire

Renesas MCU Board for 4513/4514 Group MCUs M34514T-MCU Manuel d'utilisateur Page 23