Renesas Single-Chip Microcomputer M306NKT3 Manuel d'utilisateur télécharger pdf (Page 36)

3.3 Starting FDT

3.3.1 Starting FDT without Security or Simple Interface Mode enabled

To start FDT, open the ‘Start’ menu of Windows

and select ‘Programs’ -> ‘Renesas’ -> ‘Flash

Development Toolkit 3.05’, then the ‘Flash Development Toolkit 3.05’ shortcut. The ‘Welcome’ dialog

box will open by default.

Figure 3-1 Welcome Dialog

To create a new workspace, select ‘Create a new Project Workspace’ and click the ‘OK’ button (see

section 3.4.1 for details). To open a recent workspace, select ‘Open a recent project workspace’ and the

workspace to be opened from the list box. To open an existing workspace which is not in the list of

recently used workspaces, select ‘Browse to another project Workspace’. Finally, click the ‘OK’ button.

3.3.2 Starting FDT in Basic Simple Interface Mode

To start FDT in Basic Simple Interface Mode, open the ‘Start’ menu of Windows

and select

‘Programs’ -> ‘Renesas’ -> ‘FLASH Development Toolkit 3.05’, then the ‘Flash Development

Toolkit 3.05 Basic’ shortcut. The previous FDT Basic settings will be restored, and new settings can be

entered by selecting the Options->New Settings… menu item.

3.3.3 Starting FDT by double clicking on a workspace file

FDT can be started by double clicking on a workspace file from Windows

Explorer. This will cause

FDT to load the selected workspace upon start up.

3.3.4 Starting FDT by double clicking on a data file

FDT can be started by double clicking on a registered data file from Windows

Explorer (if this default

option was not unselected during installation). This will cause FDT to load the selected data file upon

start up.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 146 147

Pas de commentaire

Renesas Single-Chip Microcomputer M306NKT3 Manuel d'utilisateur Page 36