Renesas Single-Chip Microcomputer M37900T2-RPD-E Manuel d'utilisateur télécharger pdf (Page 31)

( 31 / 52 )

(3) LED Display When PC4701 Starts up Normally

After the emulator starts up, check the status of the LEDs on the front panel to see whether emulation

pod operation is enabled or not. Figure 4.1 shows front panel LED lighting status when the emulator

is turned ON.

Figure 4.1 LED display when the power turned on

IMPORTANT

Note on Memory Expansion Mode and Microprocessor Mode:

• To use memory expansion or microprocessor mode, be sure to set the RDY and

HOLD pins so that they are not active at startup. Otherwise the emulator system will

not start up correctly.

• If this does not light, check the voltage of the target system.

• Check that power is supplied to all the terminals.

• This does not light when the target system is not connected.

• If this lights, check the reset pin of the target system.

: ON

: OFF

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Pas de commentaire

Renesas Single-Chip Microcomputer M37900T2-RPD-E Manuel d'utilisateur Page 31