Renesas Pod Probe for 7906 Group MCUs M37906T-PRB Informations techniques télécharger pdf (Page 22)

( 20 / 40 )

Chapter 3. Setting Up

With this product, it is necessary to set the following according to your target system.

• Setting switches

• Mounting the A-D conversion bypass capacitor

3.1 Switch Settings

It is necessary to set the switches of the M37906T-PRB for debugging according to the target system.

Figure 3.1 shows the positions of the switches of the M37906T-PRB, and Table 3.1 shows the switch

settings.

Figure 3.1 Positions of the switches and their factory-settings

Table 3.1 Switch settings of M37906T-PRB

Function Switch settingSwitch No.

OUT

output

selected

JP1

PLL filter

circuit

selected

JP2

When using the PLL filter circuit on

the target system or not using the

PLL function (Factory-setting)

When using the PLL filter circuit on

the pod probe

Does not output X

OUT

(Factory-setting)

Outputs XOUT

XOUT N.C XOUT N.C

CAUTION

Note on Switch Settings:

• Always shut OFF power before setting switches. The power ON state could destroy

internal circuits.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Pas de commentaire

Renesas Pod Probe for 7906 Group MCUs M37906T-PRB Informations techniques Page 22