Renesas HS2378KCI01H Informations techniques télécharger pdf (Page 10)

3. #RES of pin 4 of the Hitachi-UDI port connector is a signal line in which the

emulator outputs signals to the MCU. An AND operation must be performed

between #RES and the user system reset circuit for the signal line connected to

the MCU.

#RES of pin 7 of the Hitachi-UDI port connector is a signal line in which the

emulator monitors the #RES signal of the MCU.

The #RES must be pulled up before it is connected to pin 7 of the Hitachi-UDI

port connector.

Figure 4.4 Examples of Reset Circuits

4. Ground pins 8 to 10 and 12 to 14 of the Hitachi-UDI port connector.

5. Pin 11 of the Hitachi-UDI port connector must be connected to the user system

Vcc (power supply). The amount of voltage permitted to input to the Hitachi-

UDI port connector must be within the guaranteed range of the microcomputer.

6. Figure 4.5 shows the interface circuit in the emulator. Use this figure as a

reference when determining the pull-up resistance value.

Figure 4.5 Interface Circuit in the Emulator (Reference)

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Renesas HS2378KCI01H Informations techniques Page 10