Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E Informations techniques télécharger pdf (Page 19)

( 17 / 32 )

Chapter 4. Setting Up

4.1 Removing the Upper Cover

If you need to change the input frequency, remove the upper cover of the product to change the

configuration.

(1) Remove the four screws of both sides and lift off the upper cover. (see Figure 4.1)

(2) Change the input frequency following the instructions shown below.

(3) Replace the upper cover and tighten the four screws.

Figure 4.1 Removing the upper cover

Caution

Before Removing the Upper Cover:

• Always shut OFF power before removing the cover and changing the oscillator

circuit board. Removing the cover and setting switches in the power ON state could

destroy internal circuits.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Pas de commentaire

Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E Informations techniques Page 19