Renesas Emulator System SH7362 Manuel d'utilisateur télécharger pdf (Page 34)

E1/E20 Emulator Appendix A

R20UT0398EJ0400 Rev.4.00 Page 34 of 39

May 16, 2014

(3) As soon as the self-checking program is started.

“TEST1 is running.” and “TEST2 is running.” are shown on the screen. If the emulator correctly completes TEST1

and TEST2, “TEST1: PASS” and “TEST2: PASS” are displayed.

Figure A.7 Running the Self-Checking Program

(4) When TEST3 is entered, the following message appears.

“Please remove the User interface cable from the self-checking connector to execute TEST3.”

After this message has been displayed, disconnect the user interface cable from the self-checking connector and

close the lid of the self-checking connector. Then click on the [OK] button to continue with the self-checking

process.

If the user interface cable is still connected to the self-checking connector or user system, clicking on the [OK]

button does not restart the self-checking process.

Figure A.8 Message [Please remove the User interface cable from

the self-checking connector to execute TEST3.]

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Pas de commentaire

Renesas Emulator System SH7362 Manuel d'utilisateur Page 34