Renesas Single-Chip Microcomputer M38C89T-ADF Manuel d'utilisateur télécharger pdf (Page 23)

M38000T2-CPE User’s Manual 2. Setup

R20UT0213EJ0600 Rev.6.00 Page 23 of 82

Oct. 20, 2010

2.4 Connecting the Power Supply for the Emulator

Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the emulator

is listed in Table 2.1.

Table 2.1 Specification of power supply of the emulator

Power supply voltage

DC 5.0 V±5％/2 A

Figures 2.3 and 2.4 show the specifications of the power connector (J1) and an applicable plug, respectively.

Electrode (-) Electrode (+)

4.75mm

1.7mm(Inside diameter)

Figure 2.3 Power connector specifications Figure 2.4 Applicable plug specifications

CAUTION

Notes on Connecting a Power Supply of the Emulator:

• The power cable included in this product package is colored red (+) and black (-).

• Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy internal

circuits.

• Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause burn

injuries and the failure of internal circuits.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Pas de commentaire

Renesas Single-Chip Microcomputer M38C89T-ADF Manuel d'utilisateur Page 23