Renesas SuperH SH7280 Series Manuel d'utilisateur télécharger pdf (Page 101)

8.1.3. Programming

① Download

・ Download programming data to S550-SFWv3.

*The programming data shall be downloaded to the main unit for stand-alone programming. (For downloading, see “7.4

Downloading”.)

② Connect the S550-SFWv3 main unit and target board

・ Connect S550-SFWv3 and the target board with the target connecting cable.

*For connection in stand-alone mode, see “4.2 Connection for Stand-alone Programming / Stand-alone Initializing”.

③ Power ON

・ Turn on the target board.

④ Confirm S550-SFWv3 start up

・ For the LED and buzzer status at the startup, see “9.2 LED Status List” and “9.3 Buzzer Sound List”.

⑤ Start programming

・ Press the “START” switch and the programming will start.

⑥ Programming complete

・ Execution result will be output with the LED and buzzer.

(See “9.2 LED Status List” and “9.3 Buzzer Sound List”)

・ Check the execution detail result with the error information display on the center display.

(See “8.4.5 Error Information Display”)

⑦ Power OFF

・ Turn off the target board and disconnect the S550-SFWv3 and the target board.

To continue programming the same data, repeat the procedures 2 through 6 again.

Serial Flash Programmer[S550-SFWv3] Operation Manual 100

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 119 120

Pas de commentaire

Renesas SuperH SH7280 Series Manuel d'utilisateur Page 101