Renesas FLASH Development Toolkit 3.07 Manuel d'instructions Page 2
- Page / 73
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
© G4S Technology 2009
All rights reserved. No part of this publication may be reproduced in any form without the written permission of
G4S Technology Limited.
G4S Technology Limited cannot be held liable for technical and editorial omissions or errors made herein; nor
for incidental or consequential damages resulting from the furnishing, performance or use of this material.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference. In which case, the
user will be required to correct the interference at his own expense.
Access Control Design Guide
MAN-M2150/ENG
(9600-0420)
Issue 1.4 – 1
st
November 2010
All trademarks acknowledged.
ENVS and Symmetry are trademarks of G4S Technology Limited.
MIFARE is a registered trademark of NXP Semiconductors.
HID is a registered trademark of HID Corporation.
Texas Instruments is a trademark of Texas Instruments Incorporated.
iCLASS is a trademark of HID Corporation.
- Access Control 1
- Design Guide 1
- Contents 3
- 1 Preface 5
- About Symmetry 7
- Symmetry M2150 7
- Summary of M2150 Components 9
- Access Control Design Guide 10
- Examples of Equipment Use 13
- M2150 System 14
- Siting of Elevator Nodes 20
- Cable Requirements 21
- Fireman's Switch 22
- Free/Secure Relay 22
- Tenant Security 22
- Federal Fire Code 23
- Choosing the Cabinets 24
- Planning Antipassback 26
- Selecting the Readers 28
- Using RS485 Readers 29
- Power for Door Releases 30
- Using Noise Suppression 30
- Choosing Cable Supervision 31
- Introduction 33
- AC Monitor 34
- Current Consumption @12Vdc 35
- Cable Supervision 37
- Six-State Supervision 38
- • Alarms controllers 38
- Business 39
- Professional 39
- Enterprise 39
- Software Sentinels Required 42
- Installation Requirements 43
- Procedures 44
- LEDs on the 4DBC 45
- LEDs on the 8DBC and 8DC 46
- LEDs on the 2DC 47
- LEDs on the 4DC 48
- LEDs on the DBU 49
- Fuse Ratings 50
- Updating Firmware 51
- Selecting Device shows 53
- Other Options at 58
- (UL) Compliance 60
- Electrical 62
- Standards 62
- Physical 62
- Environmental 63
- System Limits 63
- Card Readers 63
- E Index 69
- See Cabinet 70
- See Cable 73
Sennheiser Teléfonos manuales de usuario
Empezando en P
Commentaires sur ces manuels