Renesas FLASH Development Toolkit 3.07 Manuel d'utilisateur télécharger pdf (Page 17)

RLCD2378 User’s Manual Rev 1.1 17/ 19 September 2007

Note: the external flash addresses are also mirrored from H’ 80000 to H’ 3FFFFE.

Figure 7.1 RLCD2378 Memory Map

7.2. Hardware Specifications

Table 7-1 lists the specifications of the RLCD2378 Board.

Table 7-1: RLCD2378 Board Specifications

Item Specification

MCU F2378VF034. Max clock frequency 34MHz

Clock Main Clock: crystal 16 MHz (for LCD operation, PLL set to x2)

Memory

RAM: 32kB

Flash ROM: 512kB

User interface A “ring” of headers (unpopulated) on the RSKH8S2378 board (see RSK

User Manual

External SRAM 1M x 16, Cypress CY7C1061AV33

External Flash 2M x16, Samsung K8P3215UQB

7.3. Power Supply Requirements

The RLCD2378 Board requires a 5.0V DC voltage supply and will draw about 1.3 amps (approximately 1

amp for the LCD backlight. Power to the board MUST connect to the lower (daughter) board connector J9.

7.4. Operating Environment

Table 7-2 lists the environmental conditions for using and storing the RLCD2378 board. Store the board

in a conductive bag inside the original factory packaging.

Table 7-2: Operating and Storage Environments

Environmental Condition Ambient Temperature Ambient Humidity

Operating 0 to 55°C

(No corrosive gas allowed)

30 to 80% (non-condensing)

Storage -30 to 75°C

(No corrosive gas allowed)

30 to 80% (non-condensing)

1 2 ... 12 13 14 15 16 17 18 19

Pas de commentaire

Renesas FLASH Development Toolkit 3.07 Manuel d'utilisateur Page 17