Renesas H8S/2628 Informations techniques télécharger pdf (Page 80)

100

101

3.6 Controlling the Build

By default, the High-performance Embedded Workshop will execute all of the phases in a build and only stop if

a fatal error is encountered. You can change this behavior by setting the controls on the “Build” tab of the

“Options” dialog (figure 3.18).

Figure 3.18: Options Dialog Build Tab

Select [Tools->Options…] to invoke the dialog. If you want to stop the build when a certain number of errors

are exceeded then set the “Stop build if the no. of errors exceed” check box and then specify the error count limit

in the edit field to the right. If you want to stop the build when a certain number of warnings are exceeded then

set the “Stop build if the no. of warnings exceed” check box and then specify the warning count limit in the edit

field to the right.

Note: Irrespective of what these controls are set to, the build will always halt if a fatal error is encountered.

In addition to specifying error and warning count limits, the “Build” tab also allows you to request that the

command line, environment and initial directory of each execution should be displayed. Check the appropriate

check boxes as necessary.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 429 430

Commentaires sur ces manuels

Pas de commentaire

Renesas H8S/2628 Informations techniques Page 80

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Renesas H8S/2628