Renesas Emulator System E8 Manuel d'utilisateur télécharger pdf (Page 137)

The PC breakpoint that has been set is displayed in the [Eventpoint] window.

Figure 6.31 [Eventpoint] Window (PC Breakpoint Setting)

To stop the tutorial program at the PC breakpoint, the following procedure must be executed:

• Close the [Eventpoint] window.

• Set the program counter value (PC = H’0E6C6) that was set in section 6.8, Setting Registers,

in the [Register] window. Click the [Go] button.

• If program execution is failed, reset the device and execute again the procedures above.

The program runs, and stops at the set PC breakpoint.

Figure 6.32 [Source] Window at Execution Stop (PC Break)

119

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 165 166

Pas de commentaire

Renesas Emulator System E8 Manuel d'utilisateur Page 137