Renesas Emulator System E8 Manuel d'utilisateur télécharger pdf (Page 42)

(2) The pin assignments of the connector are shown in section 2 in the additional documents,

Notes on Connecting the xxxxx.

Figure 3.9 Connecting the User System Interface Cable to the User System

Notes: 1. To connect the signals output from the connector, refer to the MCU pin alignment.

2. To remove the user system interface cable from the user system, pull the tab on the

connector upward.

3. The range of frequencies that the emulator operates at is different according to the

MCUs used.

4. Connect the signals from the connector as shown in section 2 in the additional

documents, Notes on Connecting the xxxxx.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 165 166

Pas de commentaire

Renesas Emulator System E8 Manuel d'utilisateur Page 42