Renesas Emulation Pod M3062PT3-RPD-E Informations techniques télécharger pdf (Page 34)

( 32 / 76 )

(3) Changing the Internal Oscillator Circuit of the Emulation Pod

An oscillator circuit board for 16.0 MHz (OSC-3) is mounted on this product. To use the emulation

pod at a frequency other than 16.0 MHz, build the desired oscillator circuit on the included OSC-2

oscillator circuit board (bare board) and replace the board installed in the emulation pod when shipped

from the factory.

Figure 3.5 shows a view of the OSC-2 oscillator circuit board (bare board) and where connector pins

are located. Figure 3.6 shows the circuitry of the OSC-2 oscillator circuit board (bare board). Use the

number of oscillator circuits recommended by the oscillator manufacturer.

Figure 3.5 External view of the OSC-2 oscillator circuit board and its connector pin positions

J1-4: GND

J1-3: Oscillator output

J1-2: GND

J1-1: Vcc

Figure 3.6 Circuits of the OSC-2 oscillator circuit bare board

IC1

X1 ,X2

CLK

Vcc

GND

J1-3

1011 8

IC1

J1-1

J1-2

J1-4

GND

IC1

* X1: 5.08-mm-pitch 2-pin oscillator IC1: Inverter (Unbuffer)

* X2: 2.54-mm-pitch 2-pin oscillator

* X3: 2.54-mm-pitch 3-pin oscillator

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Pas de commentaire

Renesas Emulation Pod M3062PT3-RPD-E Informations techniques Page 34