Renesas Emulator Debugger M16C PC4701 Manuel d'utilisateur télécharger pdf (Page 22)

( 22 / 52 )

Chapter 3. Setting Up

To use this emulation pod with your application system, it is necessary to make a setting as follows.

Change the setting after removing the upper cover.

• Change the oscillation frequency in the emulation pod.

3.1 Removing the Upper Cover

The procedure of removing the upper cover is shown below.

(1) Remove the four screws of both sides of this product and lift off the upper cover (see Figure 3.1).

(2) Change the oscillation frequency in the emulation pod as described in "3.2 Selecting Clock

Supply" on pages 23 to 26.

(3) Replace the upper cover and secure the four screws.

Figure 3.1 Removing the upper cover

CAUTION

When Removing the Upper Cover:

• Always shut OFF power when removing the upper cover or setting the switches.

• Do not touch the connector pins of the emulator main unit and pod probe. Static

electricity may damage the internal circuits.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Pas de commentaire

Renesas Emulator Debugger M16C PC4701 Manuel d'utilisateur Page 22