Renesas V850E2 Manuel d'utilisateur télécharger pdf (Page 16)

 iSYSTEM, September 2014 16/23

Before the program is set to run or while it is running already, activate the trace recording by the

‘Trace begin’ tool bar or the CTRL+B shortcut key. The trace stops recording when the program

execution is stopped. After the trace stops recording, the collected information is analyzed and

displayed.

Select a start ‘Immediately’ or ‘On Trigger’ when the trace should record only until the trace buffer

gets full.

Example 2: Trace triggers when function Type_Simple() is called and program execution is recorded

around the trigger event.

Create a new Trace Trigger in the Analyzer window and open the trigger configuration dialog. First,

select ‘Enabled’ in the Trigger combo box on top of the dialog, next set Execution Watchpoint 1 for the

trigger condition and then enter Type_Simple address in the corresponding address field.

Leave the ‘Qualifier‘ pane at default setting, which records program flow only.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Renesas V850E2 Manuel d'utilisateur Page 16