Renesas Emulation Probe for M32C/87 Group M30870T-EPB Manuel d'utilisateur télécharger pdf (Page 34)

M30870T-EPB User’s Manual 2. Setup

R20UT0209EJ0400 Rev.4.00 Page 34 of 106

Aug 16, 2012

2.9.3 Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 2)

Figure

2.10 shows how to connect the emulation probe to a 100-pin 0.65-mm-pitch foot pattern on the user system with the

M3T-DIRECT100S (not included) (discontinued), and here following is its procedure. For details on the M3T-100LCC-DMS

and M3T-DIRECT100S, refer to each user's manual.

(1) Attach the M3T-DIRECT100S to the user system.

(2) Attach the M3T-100LCC-DMS to the M3T-DIRECT100S.

(3) Attach the M30800T-PTC to the M30870T-EPB.

(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.

M3T-100LCC-DMS

(not included)

M3T-FLX160-EPB

M30870T-EPB

CN2 side

(3)

(4)

M30800T-PTC

(2)

(1)

100 -pin 0.65-mm-pitch

(100P6S) foot pattern

No. 1 pin

User system

M3T-DIRECT100S

(not included) *

* Discontinued product

Figure 2.10 Connecting to a 100-pin 0.65-mm-pitch foot pattern (2/3)

CAUTION

Notes on Connecting the User System:

Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the

emulator and user system.

The small connectors of the M3T-100LCC-DMS and M3T-DIRECT100S are guaranteed for only 20

insertion/removal iterations.

The small connectors of the M30870T-EPB and M30800T-PTC are guaranteed for only 50

insertion/removal iterations.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 105 106

Pas de commentaire

Renesas Emulation Probe for M32C/87 Group M30870T-EPB Manuel d'utilisateur Page 34