Renesas Emulation Probe for M32C/87 Group M30870T-EPB Manuel d'utilisateur télécharger pdf (Page 93)

M30870T-EPB User’s Manual 4. Hardware Specifications

R20UT0209EJ0400 Rev.4.00 Page 93 of 106

Aug 16, 2012

Notes on Debugging in CPU Rewrite Mode:

To debug a program in CPU rewrite mode, select the check box "Debug the program using the CPU

Rewrite Mode" in the MCU tab of the Init dialog box. When you do not debug a program in CPU rewrite

mode, clear the check box.

When you debug a program in CPU rewrite mode, the block 0 area (FFF000h--FFFFFFh) must not be

rewritten. Otherwise, the emulator will be out of control.

When debugging in CPU rewrite mode is enabled, you cannot use the following functions.

(1) Setting an address match breakpoint

(2) Setting a software breakpoint to the internal ROM area

(3) Executing COME to the internal ROM area

Do not use the following functions to the rewrite control program area (from setting CPU rewrite mode

select bit to releasing it). If any of these are used, malfunctions may occur (e.g. The emulator cannot

shift to CPU rewrite mode or contents of ROM cannot be read out properly.).

(1) Single stepping

(2) Setting a software breakpoint

(3) Setting a hardware breakpoint

(4) Executing COME

When CPU rewrite program is allocated to the expansion emulation memory, the program may run out

of control. For the CPU rewrite program, use an internal RAM area or external resource on the use

system. These precautions only need to be observed when using an emulator, and do not apply for the

actual MCU.

Note on Software Break:

A software break generates a break interruption by forcibly inserting a BRK instruction "08h" instead of

an instruction code. Therefore, when referencing the result of a trace in bus mode, "08h" is displayed for

the instruction fetch address where a software break is set.

Notes on Service-Life of the MCU's Internal Flash ROM:

With the M30870T-EPB, programs are downloaded to the MCU's flash ROM when debugging in single-

chip mode or memory expansion mode. Because the number of write/erase cycles of this ROM is

limited, the ROM must be replaced when at the end of its service-life.

If the following errors occur frequently during program download, replace the emulation probe or

request for repair.

(1) Flash ROM erase error occurred ERROR (16258)

(2) Flash ROM verify error occurred ERROR (16259)

To purchase the product for replacement or request for repair, contact your local distributor.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 105 106

Pas de commentaire

Renesas Emulation Probe for M32C/87 Group M30870T-EPB Manuel d'utilisateur Page 93