Renesas HS6400FDIW3S Manuel d'utilisateur télécharger pdf (Page 35)

3.3.5 Connection Type

Select whether the connection is for Boot Mode or User Mode in the ‘Connection Type’ dialog.

Additionally, for a connection to a kernel that is still running on the device from a previous session,

select the ‘Kernel already resident’ check box. Next, select the communication speed (bps) if the

default value is not correct or not present. Speeds where the target error rate is greater than 4%, or the

FDM error rate is greater than 0% are automatically removed from the recommended list. When using

the FDM with FDT 3.1 kernels the ‘User Specified’ connection speed option is enabled; when

selected, this allows the user to specify a non-standard baud rate. The error rate will be displayed –

this takes into account the target peripheral clock rate, the target Bit Rate Register calculation formula,

and the FDM characteristics.

Click the ‘Next’ button to continue.

Figure 3-6 Connection Type

Note that ‘Use Default’ is designed for use with the RENESAS Evaluation Board or Evaluation

Development Kits. Uncheck this to allow manual selection of the bit rate.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 93 94

Pas de commentaire

Renesas HS6400FDIW3S Manuel d'utilisateur Page 35