Renesas SH7210 Series Manuel d'utilisateur télécharger pdf (Page 58)

The [Event Condition 11] dialog box is used to specify the count of [Event Condition 1] and

becomes a reset point when the sequential condition is specified.

Sequential Setting: Use the [Combination action(Sequential or PtoP)] dialog box to specify the

sequential condition and the start or end of performance measurement.

Table 3.10 Conditions to Be Set

Classification Item Description

[Ch1, 2, 3] list box Sets the sequential condition and the start or end of performance

measurement using Event Conditions 1 to 3 and 11.

Don’t care Sets no sequential condition or the start or end of

performance measurement.

Break: Ch3-2-1 Breaks when a condition is satisfied in the order of

Event Condition 3, 2, 1.

Break: Ch3-2-1,

Reset point

Breaks when a condition is satisfied in the order of

Event Condition 3, 2, 1.

Enables the reset point of Event Condition 11.

Break: Ch2-1 Breaks when a condition is satisfied in the order of

Event Condition 2, 1.

Break: Ch2-1,

Reset point

Breaks when a condition is satisfied in the order of

Event Condition 2, 1.

Enables the reset point.

I-Trace stop: Ch3-2-1 Halts acquisition of an internal trace when a

condition is satisfied in the order of Event Condition

3, 2, 1.

I-Trace stop: Ch3-2-1,

Reset point

Halts acquisition of an internal trace when a

condition is satisfied in the order of Event Condition

3, 2, 1.

Enables the reset point.

I-Trace stop: Ch2-1 Halts acquisition of an internal trace when a

condition is satisfied in the order of Event Condition

2, 1.

I-Trace stop: Ch2-1,

Reset point

Halts acquisition of an internal trace when a

condition is satisfied in the order of Event Condition

2, 1.

Enables the reset point.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 89 90

Pas de commentaire

Renesas SH7210 Series Manuel d'utilisateur Page 58