Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur télécharger pdf (Page 100)

2.3 Re-connecting the Emulator

When the emulator is disconnected, re-connection is possible by using the following methods.

Select [Debug -> Connect] or click the [Connect] toolbar button (

) to re-connect the emulator.

Note: When re-connecting the emulator, the load module must be registered to the High-performance

Embedded Workshop beforehand.

2.4 Ending the Emulator

The emulator can be exited by using the following two methods:

(a) Canceling the connection of the emulator being activated

Select [Debug -> Disconnect] or click on the [Disconnect] toolbar button (

(b) Exiting the High-performance Embedded Workshop

1. Select [File -> Exit].

2. A message box is displayed. If necessary, click the [Yes] button to save a session. After saving a session,

the High-performance Embedded Workshop exits.

Figure 2.13 [Session has been modified] Message Box

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 242 243

Pas de commentaire

Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur Page 100