Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur télécharger pdf (Page 141)

(3) [Trace Acquisition Condition Channel n] dialog box

Use this dialog box to set pass points and a reset point for a sequential trace stop, and conditions in the address

range trace, address range conditional trace, conditional trace, Point to Point trace, execution time measurement,

and a trigger output.

Figure 3.29 [Trace Acquisition Condition Channel n] Dialog Box

The [Trace Acquisition Condition Channel n] dialog box has pages [Action], [Address], [Data], [Bus/Area],

[Probe], [Interrupt], [Count], and [Delay]. The user can make more complex settings by a combination of

conditions provided on these pages.

[Action]

[After Condition Match]: Selects an action to take when a condition is satisfied.

[Trace Stop]: Selects a trace stop.

[Address Range Trace]: Selects an address range trace. Selecting this option and checking

[Combination with the next channel] allows an address range

conditional trace.

[Acquisition Condition]: Selects a conditional trace.

[None]: Select this option if you do not want to take any of the actions listed

above. This is useful for a trigger output or execution time

measurement.

[Address]: Sets the start and end addresses of the range in the address range trace,

address range conditional trace, or Point to Point trace.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 242 243

Pas de commentaire

Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur Page 141