Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur télécharger pdf (Page 143)

3.8.4 Searching for a Trace Record

Use the [Trace Find] dialog box to search for a trace record. To open this dialog box, choose [Find...] from the

popup menu.

Figure 3.30 [Trace Find] Dialog Box

The [Trace Find] dialog box has the following options:

[General]: Sets the range for searching.

[Not designation]: Searches for information that does not match the conditions set in other

pages when this box is checked.

[Upward search]: Searches upwards when this box is checked.

[Start PTR]: Enters a PTR value to start a search.

[End PTR]: Enters a PTR value to end a search.

[Address]: Sets an address condition.

[Don't care]: Detects no address when this box is checked.

[Value]: Enter the address value (not available when [Don’t care] has been checked).

[Data]: Sets a data condition.

[Don't care]: Detects no data when this box is checked.

[Value]: Enter the data value (not available when [Don’t care] has been checked).

[R/W]: Selects the type of access cycles.

[Don't care]: Detects no read/write condition when this box is checked.

[Setting]: Detects the specified read/write condition.

RD: Read cycle

WR: Write cycle

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 242 243

Pas de commentaire

Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur Page 143