Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur télécharger pdf (Page 153)

Table 3.2 Mode Settings for Measurement

Point

Measurement Mode

1 2 3 4 5 6 7 8

Time Of Specified Range

Measurement

Ο Ο Ο Ο Ο Ο Ο Ο

Start Point To End Point

Measurement

Ο Ο Ο Ο Ο Ο Ο Ο

Start Range To End

Range Measurement

Ο ⎯ Ο ⎯ Ο ⎯ Ο ⎯

Access Count Of

Specified Range

Measurement

Ο ⎯ Ο ⎯ Ο ⎯ Ο ⎯

Called Count Of

Specified Range

Measurement

Ο ⎯ Ο ⎯ Ο ⎯ Ο ⎯

Note: Ο: Available

⎯: Not available

Note: Only one point is used in Time Of Specified Range Measurement and Start Point To End Point

Measurement, while two sequential points are used in Start Range To End Range Measurement, Access

Count Of Specified Range Measurement, and Called Count Of Specified Range Measurement. The

conditions that have been set will be canceled when switching these modes of different types.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 242 243

Pas de commentaire

Renesas User System Interface Board HS7047ECH61H Manuel d'utilisateur Page 153