Renesas R8C/Tiny Series Manuel télécharger pdf (Page 183)

R8C/10 Group 19. Usage Notes

Rev.1.20 Jan 27, 2006 page 173 of 180

REJ09B0019-0120

19.8 Noise

(1) Bypass Capacitor between VCC and VSS Pins

Insert a bypass capacitor (at least 0.1 µF) between VCC and VSS pins as the countermeasures against

noise and latch-up. The connecting wires must be the shortest and widest possible.

(2) Port Control Registers Data Read Error

During severe noise testing, mainly power supply system noise, and introduction of external noise, the

data of port related registers may changed. As a firmware countermeasure, it is recommended to

periodically reset the port registers, port direction registers and pull-up control registers. However, you

should fully examine before introducing the reset routine as conflicts may be created between this

reset routine and interrupt routines (i. e. ports are switched during interrupts).

(3) CNVss Pin Wiring

In order to improve the pin tolerance to noise, insert a pull down resistance (about 5 kΩ) between

CNVss and Vss, and placed as close as possible to the CNVss pin.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 198 199

Pas de commentaire

Renesas R8C/Tiny Series Manuel Page 183